Loading ...
Loading ...
Loading ...
5
2. ASSEMBLY
For KFA50DGD/80DGD Models only
(Assembly time for this product is 3 minutes)
Tools Required
• Medium Phillips Screwdriver.
1) Lift front guard for arrow direction and make
sure that guard’s wedged portion ts into the slit
hole on the upper housing.
2) Remove the pre-assembled screws on the shell
upper.
3) Align the holes in the upper housing with two
mounting holes on the handle as shown in
Figure 6.
4) Secure handle with the screws removed.
For KFA135DGD/180DGD/220DGD Models only (Assembly time for this product is 10 minutes)
Tools Required
• Medium Phillips Screwdriver.
• 3/4 inch socket or adjustable wrench
Assembling Handle & Wheel and Cord Wrap
1) Slide threaded axle through the rear section of the wheel support frane.
2) Slide one axle bushing on to each side of the axle. Slide one wheel on to each side of the axle.
Attach one cap nut on to each side of the threaded axle and tighten well.
3) Place heater on wheel support frame. Align the holes on fuel tank ange with holes on wheel support
frame.
4) Position the Handles on top of fuel tank ange.
Insert screws through handles, fuel tank ange and wheel support frames as shown in Figure 8 and
attach nut nger tight after each screw is inserted.
5) Align the hole on the handles with the mounting hole on the Cord Wrap.
Insert Screws through Cord Wrap, handles and attach nut nger tight after each screw is inserted.
6) After all screws are inserted, tighten nuts rmly.
Figure 6. Assembling Handle
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Handle
Screw
Front Guard
Wedged Portion
Slit Hole
Shell Upper
Remove Screws
Loading ...
Loading ...
Loading ...