Loading ...
Loading ...
Loading ...
9
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
NOTICE : The major electrical components of this heater are protected by a safety fuse mounted to the PCBboard.
If your heater fails to start, check this fuse first and replace as necessary. You should also check your
power source to insure that proper voltage and frequency are being supplied to the heater.
TO STOP HEATER
1. Turn switch to “OFF” and unplug power cord.
TO RESTART HEATER
1.Wait 10 seconds after stopping heater.
2. Repeat steps under to start heater.
PIGGYBACK POWER CORD
WARNING : SHOCK HAZARD!
8. LONG TERM STORAGE OF YOUR HEATER
FUEL TANK DRAIN
1. Drain fuel tank through fuel cap opening.
(For KFA50DGD/80DGD Models Only)
2. Remove fuel drain bolt from rear bottom side of fuel tank using 3/4” socket or adjustable wrench and drain.
(For KFA135DGD/180DGD/220DGD Models Only. See Figure 10)
3. Using a small amount of kerosene, swirl and rinse the inside of the tank.
NEVER
mix water with the kerosene as it will cause rust inside the tank.
Pour the kerosene out making sure that you remove it all.
IMPORTANT : Do not store kerosene over summer months for use during next heating season.
Using old fuel could damage heater.
4. Reinstall fuel cap. Properly dispose of old and dirty fuel.
(For KFA50DGD/80DGD Models Only)
5. Reinstall fuel drain bolt to Fuel tank and tighten firmly using 3/4” socket
or adjustable wrench.
(For KFA135DGD/180DGD/220DGD Models Only.
See Figure 10)
IMPORTANT : Before reinstalling the fuel drain bolt, make sure the
seal is on the bolt. If the seal is not used the bolt cannot
be installed correctly and the fuel tank will leak.
6. Store heater in dry well ventilated area. Make sure storage place is free
of dust and corrosive fumes.
7. Store the heater in the original box with the original packing material and keep the USER’S MANUAL
with the heater.
• Always cover electric outlet when not in use.
• Don’t plug and use a appliance more than 120V/60Hz 5A
current in this outlet.
Figure 10. Fuel Drain Bolt
Fuel Drain Bolt
Seal
revoC
KFA80DGD/135DGD/180DGD/220DGD Models only
Figure 9. Piggy Back Power Cord
Outlet
Figure 8. Controls for All Models
Power/Reset
Switch
KFA50DGD/80DGD Models KFA135DGD/180DGD/220DGD Models
Room Temp. Display
Power/Reset
Switch
Thermostat
Control Knob
(KFA80DGD MODEL ONLY)
Thermostat
Control Knob
Lamp
Lamp
Fan Guard
Btu Control Switch
Btu Control Switch
Push to"HIGH"
Push to"LOW"
Relief Valve
Loading ...
Loading ...
Loading ...