Loading ...
Loading ...
Loading ...
19
INSTALLATION
Reversing Door Opening Direction
Reversing the Refrigerator Handle
1
Loosen the set screws with a
3
/
32
in.
(2.5 mm) Allen wrench and remove the
handle.
2
Loosen the mounting fasteners that
connect to the refrigerator door and handle
using a
1
/
4
in. (6.35 mm) Allen wrench, and
remove the mounting fasteners.
3
Carefully loosen the plug buttons
4
them counter-clockwise and continuing
until they loosen and fall out The buttons
were installed without pressure, and for
this reason, they can be unscrewed using
the plug buttons
5
on the left side.
4
Assemble the mounting fasteners at
both ends of the handle using a
1
/
4
in.
(6.35 mm) Allen wrench.
5
the handle footprints over the mounting
fasteners and tightening the set screws
with a
3
/
32
in. (2.5 mm) Allen wrench.
NOTE
To assist in the installation of the handle
Door reversal must be done by an authorized
installer or service person. If it is not, the doors
will not be covered by the warranty.
on the right side, place a piece of
masking tape near the top of the handle
before removing it.
The appearance of the handle may
vary from what is shown in the illustrations
.
4
5
ENGLISH
Loading ...
Loading ...
Loading ...