Loading ...
Loading ...
Loading ...
7
Method B - To permanently connect to household
or field wiring
1. Remove the dishwasher electrical supply junction
box cover and connect to the power supply cord
from the house installation (see Figure 7).
2. Remove 2Ǝ to 3Ǝ (51 – 76 mm) of the outer
casing of the household or field supply wiring as
shown in Figure 8. Remove 3/8Ǝ to 1/2Ǝ (10 – 13
mm) of the insulation from each wire as shown in
Figure 8.
Figure 8
3. Insert the bare copper or green wire(ground) to
the “G” ground connection “ ” of the terminal
block and securely tighten the terminal block
screw (see Figure 7).
4. Insert the white (neutral) wire to the “N”
connection of the terminal block and securely
tighten the terminal block screw.
5. Insert the black (hot) wire to the “L” connection of
the terminal block and securely tighten the
terminal block screw.
6. Check all electrical connections to make sure
they are secure and then attach the junction box
cover with the 4 screws.
WARNING
Avoid Electrical Shock Hazard!
To avoid possible injury or property damage, care
should be exercised when the dishwasher is installed
or removed to reduce the likelihood of damage to the
power cord.
Inlet Water Connections
Hot Water Supply
The hot water heater should be set to deliver
approximately 120° F (49° C) water to the
dishwasher. Water that is too hot can cause some
detergents to lose effectiveness. Lower water
temperatures will increase run times. The hot water
supply pressure must be between 15 - 145 psi (1 -
10 bar).
IMPORTANT NOTES:
x If using a solder joint instead of a compression
fitting, be sure to make all solder connections
before connecting the water supply line to the
dishwasher.
x Make sure there are no sharp bends or kinks in
the water line that might restrict water flow.
x Always use the appropriate seal when making
plumbing connections.
x Before connecting the water supply line to the
dishwasher, flush the incoming water line for
approximately 5 minutes to clear any foreign
material.
x Turn on the water supply and check for leaks
after connections are made.
WARNING
Avoid Scald Hazard!
Do not perform any work on a charged hot water line.
Serious injury could result. Only qualified plumbers
should perform plumbing work. Do not attempt any work
on the dishwasher hot water supply plumbing until you
are certain the hot water supply is shut off.
CAUTION
Temperatures required for soldering and sweating will
damage the dishwasher. If plumbing lines are to be
soldered or sweated, keep the heat source at least 6
inches (152.4 mm) away from the dishwasher.
Water Supply Shut Off Valve
Install an easily accessible shut-off valve (not
supplied) in the hot water supply line, as shown in
Figure 9. All solder connections must be made
before the water line is connected to the
dishwasher.
Loading ...
Loading ...
Loading ...