Loading ...
Loading ...
Loading ...
9
Installation of Rubber Drain Hose Adaptor
For a large port, use the drain hose as it is.
1. For a small port, insert the rubber drain hose
adaptor into the drain hose end.
2. Obtain the Rubber Drain Hose Adaptor (J) spring
clamp from the Dishwasher Installation Kit (do
not substitute).
3. Insert the dishwasher drain hose into the end of
the drain hose (see Figure 15). Be sure to fully
insert the drain hose.
4. Use the clamp provided to attach the Rubber
Drain Hose Adaptor to the house plumbing as
shown in Figure 16.
Figure 15
Figure 16
Installation of Mounting Brackets
CAUTION
Before installing the supplied countertop mounting
brackets, decide which method of securing the
dishwasher into its enclosure will be used. Once the
mounting brackets are installed on the dishwasher,
removing them is difficult and will damage the mounting
brackets and the dishwasher.
The dishwasher can be secured into its enclosure in 3
ways:
NOTE: If your dishwasher opening width measures >
23
5/8
Ǝ (600mm) use the TOP or SIDE MOUNT
mounting methods. If your dishwasher opening width
measures 23
5/8
Ǝ (600 mm) use the ALTERNATE SIDE
MOUNT mounting method.
Top Mount is used for countertops made of wood
or other materials that can be easily drilled. Orient
the mounting brackets as shown in Figure 17, and
position the two small tabs on the mounting
brackets over the two slots on the dish-washer’s
front corners. Push the mounting brackets down
firmly to insert the tabs into the slots
Figure 17
Side Mount is used for countertops made of marble,
granite, or other very hard materials that cannot be
easily drilled. Bend the mounting brackets along the
small holes and in the same direction as the two
small tabs. Orient the mounting brackets as shown
in Figure 18, and position the two small tabs on the
mounting brackets over the two slots on the
dishwasher’s front corners. Push the mounting
brackets down firmly to insert the tabs into the slots.
Bend perforated edge down as shown.
Figure 18
Alternate Side Mount for opening 23
5/8
Ǝ (600 mm).
Insert a side mount force distributor (M) in each side
as shown in Figure 19.
Figure 19
Loading ...
Loading ...
Loading ...