Loading ...
Loading ...
Loading ...
Headlights On With Wipers
When this feature is active, the headlights will
turn on after the wipers are turned on if the
headlight switch is placed in the AUTO position
and programmable feature is set to on. In addi-
tion, the headlights will turn off when the wipers
are turned off if they were turned on by this
feature.
NOTE:
The “Headlights On With Wipers” feature can
be turned on or off using the Uconnect System.
Refer to “Uconnect Settings” in “Multimedia”
in your Owner’ s Manual for further information.
Turn Signals
Move the multifunction lever up or down and
the arrows on each side of the instrument clus-
ter display flash to show proper operation of the
front and rear turn signal lights.
NOTE:
• If either light remains on and does not flash,
or there is a very fast flash rate, check for a
defective outside light bulb. If an indicator
fails to light when the lever is moved, it would
suggest that the indicator bulb is defective.
• A “Turn Signal On” message will appear in the
instrument cluster display and a continuous
chime will sound if the vehicle is driven more
than 1 mile (1.6 km) with either turn signal
on.
Lane Change Assist — If Equipped
Tap the multifunction lever up or down once,
without moving beyond the detent, and the turn
signal (right or left) will flash three times then
automatically turn off.
WINDSHIELD WIPERS AND
WASHERS
The multifunction lever operates the windshield
wipers and washer when the ignition is placed in
the ON/RUN or ACC position. The multifunction
lever is located on the left side of the steering
column.
Wiper Operation
Rotate the end of the multifunction lever to the
first detent, past the intermittent settings for
low-speed wiper operation, or to the second
detent past the intermittent settings for high-
speed wiper operation.
CAUTION!
• Turn the windshield wipers off when driv-
ing through an automatic car wash. Dam-
age to the windshield wipers may result if
the wiper control is left in any position
other than off.
• In cold weather , always turn off the wiper
switch and allow the wipers to return to the
park position before turning off the engine.
If the wiper switch is left on and the wipers
freeze to the windshield, damage to the
wiper motor may occur when the vehicle is
restarted.
• Always remove any buildup of snow that
prevents the windshield wiper blades from
returning to the off position. If the wind-
shield wiper control is turned off and the
blades cannot return to the off position,
damage to the wiper motor may occur .
GETTING TO KNOW YOUR VEHICLE
32
Loading ...
Loading ...
Loading ...