Loading ...
Loading ...
Loading ...
remain in the ACC position. The system will
automatically time out and the ignition will
cycle to the OFF mode after 30 minutes of
inactivity if the ignition is left in the ACC or RUN
(engine not running) mode and the transmission
is in P ARK.
ENGINE START/STOP Button Functions — With
Driver’s Foot OFF The Brake Pedal (In PARK Or
NEUTRAL Position)
The ENGINE ST AR T/STOP button operates
similar to an ignition switch. It has three modes:
OFF, ACC, and RUN. To change the ignition
modes without starting the vehicle and use the
accessories, follow these directions:
1. Start with the ignition in the OFF mode.
2. Push the ENGINE START/STOP button once
to place the ignition to the ACC mode.
3. Push the ENGINE ST AR T/STOP button a
second time to place the ignition to the RUN
mode.
4. Push the ENGINE ST AR T/STOP button a
third time to return the ignition to the OFF
mode.
ENGINE BREAK-IN
RECOMMENDATIONS
For vehicles equipped with the 3.6L or 5.7L use
the following engine break-in recommenda-
tions:
A long break-in period is not required for the
drivetrain (engine, transmission, clutch, and
rear axle) in your new vehicle.
Drive moderately during the first 300 miles
(500 km). After the initial 60 miles (100 km),
speeds up to 50 or 55 mph (80 or 90 km/h) are
desirable.
While cruising, brief full-throttle acceleration
within the limits of local traffic laws contributes
to a good break-in. However , wide-open throttle
acceleration in low gear can be detrimental and
should be avoided.
The engine oil, transmission fluid, and axle
lubricant installed at the factory is high-quality
and energy-conserving. Oil, fluid, and lubricant
changes should be consistent with anticipated
climate and conditions under which vehicle
operations will occur . For the recommended
viscosity and quality grades, refer to “Fluids
And Lubricants” in “Technical Specifications”.
CAUTION!
Never use Non-Detergent Oil or Straight Min-
eral Oil in the engine or damage may result.
NOTE:
A new engine may consume some oil during its
first few thousand miles (kilometers) of opera-
tion. This should be considered a normal part of
the break-in and not interpreted as an indica-
tion of difficulty. Please check your oil level with
the engine oil indicator often during the break in
period. Add oil as required.
For vehicles equipped with the 6.4L use the
following engine break-in recommendations:
Despite modern technology and W orld Class
manufacturing methods, the moving parts of
the vehicle must still wear in with each other .
This wearing in occurs mainly during the first
500 miles (805 km) and continues through the
first oil change interval.
109
Loading ...
Loading ...
Loading ...