Loading ...
Loading ...
Loading ...
en Faults and what to do about them.
32
The length of the pro-
gramme changes during
the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown on the display
panel.
Residual water in the left-
hand compartment for
the care product.
■ Not a fault – the effectiveness of the care product is not affected.
Odours in the washing
machine.
Run the Drum Clean or Cottons 90 °C programme without laundry.
Add washing powder or a detergent containing bleach.
Note: To prevent foaming, only use half the amount of detergent recommended
by the detergent manufacturer. Do not use detergents designed for woollens or
delicates.
The Å display lights up
in the touch display. Foam
may also be leaking from
the detergent drawer.
Have you used too much detergent?
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into the
left-hand compartment (not suitable for outdoor clothing, sportswear or items
made with down).
Use less detergent in the next washing cycle.
Repeated, intensive foam-
ing.
■ Check your basic dosage and dosage strength settings.
■ If required, use a different liquid detergent.
Detergent/fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
There is too much detergent/fabric softener in the dispensers. Do not fill above
the max. mark in the dispensers.
Loud noises, vibrations
and machine “movement”
during the spin cycle.
■ Appliance aligned? Align the appliance. ~ Page 38
■ Are the appliance feet secured? Secure the appliance's feet. ~ Page 38
■ Have the transport braces been removed? Removing the transportation
bolts. ~ Page 35
The touch display does
not work while the appli-
ance is running.
■ Power failure?
■ Have the fuses blown? Switch on/replace the fuses.
■ If the fault occurs repeatedly, call the after-sales service.
There is detergent resi-
due on the laundry.
■ Some phosphate-free detergents contain water-insoluble residue.
■ Select Rinse or brush the laundry after washing.
When the appliance is
paused, A flashes and
è lights up.
■ The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary.
■ Touch A to continue the programme.
A flashes when the
appliance is paused and
è is off.
The door is unlocked. It is possible to add laundry.
If you cannot rectify a fault yourself (after switching the machine off and on again) or a repair is required:
■ Switch off the appliance and pull out the mains plug.
■ Turn off the tap and call the after-sales service.
Faults Cause/remedy
Loading ...
Loading ...
Loading ...