Loading ...
Loading ...
Loading ...
en Operating the appliance
18
For programmes without intelligent
dosing, or as required (in which case,
set intelligent dosing to "off"), detergent
can be added manually to the left-hand
compartment.
Start the programme
Touch the control panel A.
The programme starts and the
A display lights up permanently.
The door is locked and the
corresponding display è lights up.
During the programme, the current
programme information is displayed:
■ Finished in-time or, after the washing
programme has started, the
programme duration
■ And the displays for the
programme's progress light up.
~ Page 9
Information on the following programme
steps and settings, which can be
changed during the programme
sequence, light up at half brightness.
Note: Foam detection
If the Å display also lights up, the
washing machine has detected too
much foam during the washing
programme and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next washing
cycle with the same load.
If you want to lock the programme to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
Childlock /operation lock
E 3 sec
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently in the
control panel.
To activate/deactivate the childproof
lock, touch and hold the control panel
E 3 sec for approx. three seconds. The
display switches to full brightness.
If you turn the programme selector or
touch the control panel while the
childproof lock is active, the E 3 sec
indicator flashes briefly and a signal
sounds. The programme runs through
to the end unchanged.
Notes
■ The childproof lock can be activated
regardless of the appliance's status.
■ The childproof lock remains active,
even once the washing machine has
been switched off.
■ If the appliance is switched off while
the programme is running and the
childproof lock has been activated,
the programme will resume when the
appliance is switched back on.
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
To do this, touch the control panel A.
The indicator flashes. The machine is
paused and checks whether a top-up is
possible.
If the display è goes out, a top-up is
possible. The door is then unlocked and
can be opened.
To continue the programme. touch A
again. The programme continues
automatically.
Loading ...
Loading ...
Loading ...