Loading ...
Loading ...
Loading ...
Maintenance
267
1
2
3
4
5
6
7
8
9
Changing the manual
transaxle oil
1. Raise and suitably support the
vehicle.
2. Remove the drain plug on the bot-
tom of the transaxle.
3. After the oil has drained complete-
ly, install a new gasket on the plug,
reinstall the drain plug and tighten
to 6.0~8.0 kgf•m (43~58 lb•ft,
60~80 N•m).
4. Remove the fill/check plug on the
side of the transaxle.
5. Add oil through the fill/check hole
until it reaches the bottom of the
fill/check hole.
6. Install a new gasket on the
fill/check plug.
7. Reinstall and tighten the fill/check
plug to 6.0~8.0 kgf•m (43~58 lb•ft,
60~80 N•m).
Use only the specified manual
transaxle oil. (Refer to
“Recommended Lubricants’’ later in
this section.)
1SAE7021
WARNING - Lifting your
vehicle
If you raise your vehicle, always
ensure that it is supported at all
four jacking or lift points for the
vehicle. Do not use jacks meant
for tire changes. Use only lift
equipment specifically recom-
mended for doing maintenance
work under the vehicle. Place
the vehicle and lift equipment
on a hard, level surface capable
of supporting the full weight of
the vehicle without moving or
deforming. If the support is not
stable, the vehicle could fall and
cause serious or fatal injuries.
Follow the instructions with the
lift device.
RSAA7027
Loading ...
Loading ...
Loading ...