Loading ...
Loading ...
Loading ...
725
Maintenance
MANUAL TRANSAXLE (IF EQUIPPED)
Checking the manual
transaxle oil level
1. Raise and suitably support the
vehicle.
2. Remove the fill/check plug on the
side of the transaxle.
3. Verify that the oil level reaches the
bottom of the fill/check hole. Fill as
necessary.
If the oil level is low, check for leaks
before adding oil. Do not overfill. Use
only the specified manual transaxle
oil. (Refer to “Recommended
Lubricants” later in this section.)
4. Install a new gasket on the
fill/check plug and tighten the plug
to 6.0~8.0 kgf•m (43~58 lb•ft,
60~80 N•m).
1
2
3
4
5
6
7
8
9
WARNING - Lifting your
vehicle
If you raise your vehicle, always
ensure that it is supported at all
four jacking or lift points for the
vehicle. Do not use jacks meant
for tire changes. Use only lift
equipment specifically recom-
mended for doing maintenance
work under the vehicle. Place
the vehicle and lift equipment
on a hard, level surface capable
of supporting the full weight of
the vehicle without moving or
deforming. If the support is not
stable, the vehicle could fall and
cause serious or fatal injuries.
Follow the instructions with the
lift device.
RSAA7027 2LDA7004
Loading ...
Loading ...
Loading ...