Loading ...
Loading ...
Loading ...
There are 2 ways to remove collected water:
1
Use the bucket. When the bucket is removed, the unit
will shut off. Empty and replace the bucket.
IMPORTANT: Do not use the hose if using the bucket
to collect water. When the hose is connected, water
will flow through it onto the floor instead of into the
bucket.
NOTES:
Ŷ Do not remove the bucket while the dehumidifier
is operating or if it has just stopped operating. This
might cause some water to drip from the drain
pan.
Ŷ The bucket must be in place and securely seated
for the dehumidifier to operate.
2
Use a hose. Water can be automatically emptied into
a floor drain by attaching a garden water hose (not
included).
1. Remove the bucket from the front of the unit.
2. Open the drain cover on the side of the unit.
3. Thread a garden hose (not supplied) onto the
nozzle, cut to length, and lead it to the floor drain.
4. Replace the bucket in the unit.
NOTE: The bucket must be in place and securely
seated for the dehumidifier to operate.
3
Use the internal pump. Water can be automatically
emptied into a remote location by attaching the
included pump hose.
1. Attach the pump hose to the hose connector by
pushing the tube fitting into the connector until it
fits into place (should not be able to remove the
hose when pulled).
2. Position the hose discharge to the desired location.
3. Make sure the pump is activated. To activate the
pump, press and hold the Pump On/Off button for
3 seconds. The Internal Pump On indicator light will
flash then remain illuminated once the 3 seconds
are complete.
IMPORTANT: Make sure the condensate hose is
properly connected and is not kinked, bent or cracked
as this may cause water to flow onto the floor. The
bucket must also be fully seated for the pump to work
properly. Do not operate the machine if the room
temperature is 32F or below.
NOTES:
Ŷ Maximum lift height is 16ft
Ŷ The bucket must be in place and securely seated
for the dehumidifier and pump to operate.
Make sure to install hose (included) before activating
the pump.
To Install Hose: Push in hose and gently pull to make
sure it is secure.
To Release Hose: Hold the grey ring while puling to
remove
Always make sure the water bucket is locked into place on the dehumidifier.
Using the dehumidifier.
Removing Collected Water
NOTE: Support bucket with
both hands when emptying.
6
1. Hold grey ring in
2. Pull hose out
Push hose in
Install hose at connector
on backside of machine
DO NOT kink or crimp hose,
DVLWFDQEORFNZDWHUÀRZ
CORRECT
Loading ...
Loading ...
Loading ...