Loading ...
Loading ...
Loading ...
15
CARE AND MAINTENANCE
IMPORTANT:
Switch off the air conditioner and disconnect the plug from
the power outlet
Drain water by removing the drain plug
Always transport the air conditioner in an upright position
only
CLEANING THE AIR FILTERS
• To ensure the air intake is filtered properly and to assure
that your air conditioner runs efficiently, it is recommended
to clean the air filters at least once every two weeks
• This unit has three air filters; the Silvershield pre-filter, 3M
filter, and intake hose pre-filter
• Switch off the air conditioner and remove the intake hose
filter, Silvershield pre-filter and 3M filter from the unit (Fig.
7a and Fig. 7b)
• Use a vacuum cleaner or tap lightly to remove loose dust
and dirt from the filters. Then rinse them thoroughly under
warm or cold running water (no hotter than 100F)
• Dry thoroughly before re-inserting the filters (Fig. 7c)
NOTE: Silvershield pre-filter and intake hose pre-filter are
washable and do not need to be replaced. The 3M should
be replaced every 2-3 months depending on usage. Please
contact
support@whynter.com for retail sales information
WARNING! Never operate the air conditioner without the
filter in place
CLEANING THE AIR CONDITIONER
Always switch off the air conditioner and disconnect the
plug from the power supply outlet before cleaning the air
conditioner
Use a soft damp cloth to wipe the body of the unit.
Never use harsh chemicals, oil-based products, deter-
gents, chemically treated cloths or other cleaning solu-
tions. These could possibly damage the body of the air
conditioner
END OF SEASON STORAGE
• Switch off the air conditioner and disconnect the power
plug from the power supply outlet before cleaning the air
conditioner
• To remove the hose(s) from the unit, the easiest way is to
remove take out the hose(s) and leave the connectors in
place.
• Clean the air filters
• Drain the condensed water completely
• On a warm day, turn on the Fan only mode for half a day
so that the inside can dry out completely
• Remove the batteries from the remote controller
• Wrap the cord using the Power Cord Buckle and insert the
plug into the Power Plug Socket. (Fig. 7d)
Fig. 7d
3M Filter
The Silvershield pre-
filter and intake hose
pre-filter can be
removed for cleaning
by pulling the filter
back and out
Install the Silvershield
pr
e-filter and filter
frame back to its
place
Fig. 7c
Fig. 7b
Fig. 7a
Power Cord
Buckle
Po
wer Plug
Socket
Loading ...
Loading ...
Loading ...