Loading ...
Loading ...
Loading ...
32
AU:
Unpacking
Remove the packaging with the product in place.
Cut off the packing ribbons and carefully cut open
the packaging (do not cut too deeply), remove the
packaging.
Check that the product is free from transport dam-
age. Any damage shall be reported immediately to
the carrier or seller.
Damage, faults and missing parts must be reported
immediately to the seller.
Fixing to the wall
Remove grease filter(s) before installing the cooker
hood.
Prepare the hole for the exhaust air if the cooker
hood is to be installed with outdoor venting.
Drill two holes in the wall spaced as illustrated (A).
Insert and tighten the screws so that you can still
adjust the cooker hood. Once this is done, tighten it
firmly against the wall.
10mm
260mm
NB:
Always use screws and fittings suited to the type of
wall (concrete, plasterboard etc.). If screws and fit-
tings are included with the product, make sure they
are suitable for the type of wall on which the cooker
hood is to be mounted before using them.
REMEMBER!
• The distance between the top of the hob and
the lowest part of the cooker hood must be at
least 65 cm.
• If a two-part connection tube is used, the lower
section must sit outside the upper section.
• Do not connect the cooker hood exhaust to
a duct used to circulate hot air or vent steam
from another appliance.
• Always use protective gloves when installing the
appliance!
Loading ...
Loading ...
Loading ...