Loading ...
Loading ...
Loading ...
Instructions for the installer
17
6.2 Fixing to the electric model support structure
Create an opening with the dimensions shown in the figure in the top surface of
the counter, keeping a minimum distance of 50 mm from the rear edge.
The lower part of the casing must be fully accessible after the appliance has
been installed. This appliance can be mounted against walls higher than the
work surface on condition that a distance of "X" be kept between the appliance
and the wall as shown in the figure so as to avoid damage from overheating.
Make sure that there is a minimum of 750 mm between the hob ring flames and
any shelves placed directly above them (Fig. 1). Furthermore, this kind of
appliance needs a milling on the hob top of 3 mm in depth; the measurements
are indicated in figure 4 (detail A of figure 3).
1)
(only 60 cm models)
Before positioning the hob, the supplied adhesive sponge “E” should be spread
out flat over the milling surface (fig. 3). Carry out this operation by supporting the
hob on the isolating seal and using screws and clamping brackets (Fig. 2
sequence) to fix the hob to the support structure, in order to obtain the complete
flatness. The small brackets in figure 2 are only positioned after having
mounted the hob.
2)
Loading ...
Loading ...
Loading ...