Loading ...
Loading ...
Loading ...
Instructions for the installer
15
6. POSITION NEAR THE COUNTER TOP
The following operation requires building and/or carpentry work so must be carried out by
a competent tradesman.
Installation can be carried out on various materials such as masonry, metal, solid wood or
plastic laminated wood as long as they are heat resistant (T 90°C).
6.1 Fixing to a support structure model with traditional casing (fig. 1)
Create an opening with the dimensions shown in the figure in the top surface of the
counter, keeping a minimum distance of 50 mm from the rear edge. This appliance can be
mounted against walls higher than the work surface on condition that a distance of "X" be
kept between the appliance and the wall as shown in the figure so as to avoid damage
from overheating. Make sure that there is a minimum of 750 mm between the gas rings
and any shelf that may be installed directly above them.
1)
(only 60 cm models)
Carefully position the supplied insulating seal on the outer edge of the hole on the top hob,
as indicated in figure 2. Try and make it stick to the whole surface by applying light hand
pressure. The front and back sides of the seal must be touching the hole.
complete flatness.
Trim any excess trimming from border A with care (Fig.3). The quotes in figure 2 are
references for the hole on the inside of the trimming. The small brackets in figure 4 are
only positioned after having mounted the hob.
2)
3)
Carry out this operation by supporting the hob on the isolating seal and using screws and
clamping brackets (Fig. 4) to fix the hob to the support structure, in order to obtain the
complete flatness.
4)
Loading ...
Loading ...
Loading ...