Loading ...
Loading ...
Loading ...
English 9
Before you start
Mounting the oven
A
Make sure to leave a gap (A) of at least
5 mm between the oven and each side of
the cabinet.
Fit the oven into the cabinet and x the
oven rmly on both sides using 2 screws.
After installation is complete, remove the protective lm, tape, and other packing
material, and take out the provided accessories from inside the oven. To remove
the oven from the cabinet, rst disconnect power to the oven and remove 2
screws on both sides of the oven.
WARNING
The oven requires ventilation for normal operation. Do not block the vents under
any circumstance.
NOTE
The actual appearance of the oven may differ with the model.
Before you start
Initial settings
When you power on the oven for the rst time, the default time of “12:00” appears
on the display where the hour element (“12”) blinks. Follow the steps below to set
the current time.
1. Use the / buttons to set the
hour, and then press
. The minute
element blinks.
2. Use the / buttons to set the
minute, and then press .
To change the current time after this initial
setting, hold down for 3 seconds and
follow the above steps.
New oven smell
Before using the oven for the rst time, clean inside the oven to remove the new
oven smell.
1. Remove all accessories from inside the oven.
2. Run the oven with Convection 200 °C or Conventional 200 °C for an hour. This
will burn any remaining production substances in the oven.
3. When complete, turn off the oven.
NV70K1340BS_EU_DG68-00766A_EN.indd 9 2018-12-04 AM 9:22:36
Loading ...
Loading ...
Loading ...