Loading ...
Loading ...
Loading ...
1818
Care and Cleaning of Stainless Steel
(some models)
Some models are equipped with stainless steel exterior parts.
Special care and cleaning are required for maintaining the
appearance of stainless parts. Refer to the Care & Cleaning
Table for detailed cleaning instructions.
Your oven control has been precisely set at the factory. This
setting may differ from your previous oven however, so your
recipe times may not give you the results you expect. If you
think that the oven is cooking too hot or too cool for your
recipe times, you can adjust the control so that the oven
cooks hotter or cooler than the temperature displayed.
To Adjust Oven Temperature:
1. Press
.
2. Set the temperature to 550°F (287°C) by pressing and
holding the .
3. Within 2 seconds, press and hold until the 2 digit
display appears. Release . The display now indicates
the amount of degrees offset between the original factory
temperature setting and the current temperature setting.
If the oven control has the original factory calibration,
the display will read “0.”
Changing the Oven Light (some models)
For models equipped with the interior oven light, the light
bulb is located at the rear of the oven and is covered with
a glass shield held by a wire holder. The glass shield must
be in place whenever the oven is in use.
To replace the oven light bulb:
1. Turn electrical power off at the main source or unplug
the range.
2. Press wire holder to one side to release the glass
shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder
into place.
5. Turn power back on again at the main source (or plug
the range back in).
6. The clock will then need to be reset. To reset, see
SettingtheClockandMinuteTimer in this Use &
Care Manual.
Oven
light
Wire
holder
CARE & CLEANING
Be sure the range is unplugged and all parts are COOL
before replacing oven light. Wear a leather-faced glove
for protection against possible broken glass.
CAUTION
ADJUSTING YOUR OVEN TEMPERATURE
4. The temperature can now be adjusted up or down 35°F
(17°C), in 5°F steps by pressing and holding the or
. Adjust until the desired amount of offset appears
in the display. When lowering the oven temperature, a
minus sign (-) will appear before the number to indicate
that the oven will be cooler by the displayed amount of
degrees.
5. When you have made the desired adjustment, press
to go back to the time of day display.
Oven temperature adjustments made will not change the
Self-Cleaning feature temperature.
NOTE
Loading ...
Loading ...