Loading ...
Loading ...
Loading ...
9
STEP 3 (continued)
D. Make sure the shut-off valve handle is flat against the servo lever
If the handle for your shut-off valve is already flat against the servo lever, you can
proceed to the next step.
If the handle is at an angle or raised off of the servo lever, you can adjust the height of
the servo from the valve as shown here. Use the Allen wrench provided to loosen the
screw on the servo height adjustment. Then adjust the height so that the shut-off valve
handle is flat on the servo lever. Then tighten the screw again. (Make sure the servo
motor is still positioned over the center of the shut-off valve!)
Servo
lever
Valve handle
E. Position the brackets so they’re as flat as possible on the pipe
Loosen one bracket slightly on the servo and slide it so that the bracket is as level as
possible on the pipe. Then tighten the bracket on the servo and repeat with the other
bracket.
Once you’ve tightened both brackets, make sure that the servo motor is still centered
over the shut-off valve and the valve handle is still flat against the servo lever.
Loading ...
Loading ...
Loading ...