Loading ...
Loading ...
Loading ...
8
STEP 3 (continued)
Does the centering ring fit? If not, replace it!
The servo’s centering ring should fit over the shut-off valve’s
nut as shown here. If it doesn’t, replace it with the larger
centering ring provided in the hardware kit.
1. Use the provided Allen wrench to remove the small Allen-
cap screw.
2. Remove the pre-installed (small) centering ring.
3. Install the larger centering ring. Then put the small washer
and Allen-cap screw back in place. Tighten with the Allen
wrench.
Nut
Allen wrench
Small Allen-
cap screw
Small washer
Centering ring
Centering ring
Insert (1) M5 x 30 x 0.8(mm) carriage bolt through each bracket as shown here. (If
these bolts are not long enough, use the M5 x 50 x 0.8(mm) ones instead.)
Place (1) washer, (1) spring washer, and (1) wing nut over each carriage bolt and
tighten just enough so that the servo stays mounted in place.
C. Close the brackets over the pipe
Loading ...
Loading ...
Loading ...