Loading ...
Loading ...
Loading ...
91
FCC statement to the user
A
FCC statement to the user
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the
user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FCC radiation exposure statement
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. End users must follow the
specific operating instructions for satisfying RF exposure
compliance. To maintain compliance with FCC RF exposure
compliance requirements, please follow operation instructions as
documented in this manual. This transmitter must not be co-
located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with
a minimum distance of 20 cm between the radiator and your body.
The availability of some specific channels and/or operational
frequency bands are country dependent and are firmware
programmed at the factory to match the intended destination. The
firmware setting is not accessible by the end user.
Compliance information
Model numbers: TCD846500 (four-tuner TiVo Roamio/Roamio
OTA), TCD848000 (Roamio Plus); TCD840300 (Roamio Pro);
RC30A00, RC30B00 (Remote). FCC IDs: TGN-TCD8465 (four-tuner
TiVo Roamio/Roamio OTA), TGN-TCD8400 (Roamio Plus/Roamio
Pro), TGN-RC30 (Remote)
Askey International Corporation, 800 Corporate Way, Suite B,
Fremont, CA 94538
Model numbers: WLU5054 (four-tuner TiVo Roamio/Roamio OTA),
WLU5200 (Roamio Plus/Roamio Pro). FCC IDs: H8N-WLU5054
(four-tuner TiVo Roamio/Roamio OTA), H8N-WLU5200 (Roamio
Plus/Roamio Pro)
Loading ...
Loading ...
Loading ...