Loading ...
Loading ...
Loading ...
8
Installation Requirements
FIG. 6
3 VALVE BYPASS
Central Water Filtration
System
INLET
Central Water Filtration
System
OUTLET
CONNECTING PLUMBING TO VALVE
Electrical Shock Hazard
Prior to installation on metallic plumbing,
securely install two grounding clamps and a
#4 copper wire per installation instructions.
Failure to follow these instructions can result
in death or electrical shock.
CROSS OVER
To Central Water
Filtration System
FIG. 5
Main Water Pipe
Treated
Water from
Valve
OUTLET
Untreated
Water to
Valve
INLET
In what direction
does the water flow?
Be sure to plan
piping so water
flow is to the
Central Water
Filtration System
valve INLET.
Plan a crossover
if flow is from left
to right.
FIG. 7
Pipes
Clips
1” NPT Sweat
Adapter (2)
(not included)
Bypass
Valve
Valve
Inlet
IN
OUT
Use Teflon® tape,
pipe joint com-
pound or both
INLET - OUTLET PLUMBING OPTIONS
Always install either a single bypass valve (provided)
to the contractor/plumber-supplied plumbing, as shown
in Figure 7 OR if desired, a 3 valve bypass system
(parts not included) can be installed, as shown in
Figure 6. Bypass valves allow you to turn off water to
the Central Water Filtration System for maintenance if
needed, but still have water in house pipes.
Use either:
= Copper pipe
= Threaded pipe
= PEX (Crosslinked Polyethylene) pipe
= CPVC plastic pipe
= Other pipe approved for use with potable water
IMPORTANT: Do not solder with plumbing attached to
the single bypass valve. Soldering heat
will damage the plastic valve.
Loading ...
Loading ...
Loading ...