Loading ...
Loading ...
Loading ...
Instruments and warning/control lamps
Odometer
The od
omet
er
registers the total distance
travelled by the car.
The partial odometer (trip) shows the dis-
tance travelled since the last time it was reset
to zero.
Vehicles with analogue instrument panel:
●
Briefly press the button 0.0/SET
›
›
›
Fig. 126
4
to reset the trip recorder to 0.
●
Keep the button 0.
0/SET
4
pressed for
about 3 seconds and the pr
e
vious v
alue will
be displayed.
Vehicles with digital instrument panel:
●
Set the odometer to zero via the Infotain-
ment system or the multifunction steering
wheel
›››
page 108.
Speed warning for winter tyres
If the maximum speed set is exceeded, this is
displayed on the instrument panel
›››
page 108.
The speed warning can be adjusted on the
Infotainment system: using button /
and the Vehicle > SETTINGS > Driver
Assistance
›
›
›
page 35 button.
Compass indication
Depending on the equipment, when the igni-
tion is on, the instrument panel display indi-
cates the direction in which you are driving
with a symbol, e.g. NW for Northwest.
When the Infotainment system is on and there
is no route guidance active, the graphic rep-
resentation of a compass is also shown.
Low consumption driving*
Depending on the equipment, when driving,
the display appears on the instrument
panel when the vehicle is in low consumption
status due to active cylinder management
(ACT
®
)*
›››
page 259.
Identifying letters on engine (LDM)
Vehicles with analogue instrument panel:
●
Switch the ignition on, but do not start the
engine.
●
Hold the button 0.0/SET
›
›
›
Fig. 126
4
down for more than 15 seconds to display the
identifying l
ett
ers of the v
ehicle engine.
Copyright
Legal text about the property rights and
copyrights of the instrument cluster.
WARNING
Even when the outside temperature is high-
er than freezing t
emperature, some roads
and bridges could be frozen.
●
The “ice crystal symbol” indicates that
there may be a risk of freezing.
●
At outside temperat
ures above +4°C
(+39°F), there may be ice even when the
“ice crystal symbol” is not on.
●
The outside temperature sensor takes a
guideline measurement.
Note
●
Ther
e are diff
erent instrument panels and
therefore the versions and instructions on
the display may vary. In the case of dis-
plays without warning or information texts,
faults are indicated exclusively by the con-
trol warning lamps.
●
Some indications on the instrument panel
screen may be concealed by a sudden
event, e.g. an incoming call.
●
Depending on the equipment, some set-
tings and instructions can be carried out or
displayed on the infotainment system as
well.
●
If there are several warnings at the same
time, the symbols will be displayed one af-
ter the other for a few seconds. The sym-
bols will stay on until you remove the
cause.
●
If when switching on the ignition warnings
are shown about existing faults, it might not
be possible to change the settings or show
the information as described. In this case,
go to a specialised workshop and request a
repair.
107
Loading ...
Loading ...
Loading ...