Loading ...
Loading ...
Loading ...
3-Wire Power Cord Installation
WARNING:
The neutral or ground
wire of the power cord must be connected to
the neutral terminal located in the center of
the connector block. The power leads must be
connected to the outside (brass-colored)
terminals.
Remove the 3 wire terminal screws from the
connector block. Insert screws through each power
cord terminal ring and into the connector block
until the screws engage the nuts. Be certain that the
center wire is connected to the center screw of the
connector block. Tighten screws securely.
DO NOT remove ground strap connection.
Power Cord Strain Relief Installation
A. Remove the lower rear range wiring cover to
expose the connector block and bracket.
B. Remove the knockout ring (1
3
⁄8″) located on
bracket directly below the connector. To remove
the knockout, use a pair of pliers to bend the
knockout ring away from the bracket and twist
until ring is removed.
C. Assemble the strain relief in the hole. Insert the
power cord through the strain relief and tighten.
Allow enough slack to easily attach the cord
terminals to the connector block. If tabs are
present at the end of the winged strain relief,
they can be removed for better fit.
NOTE: Do not install the power cord without a strain relief.
The strain relief bracket should be installed before
reinstalling the rear range wiring cover.
Wiring cover
(shown removed)
Connector box
Power cord
Ground
strap
Strain relief bracket
(Provided with range cord.
Not part of range.)
Strain relief
Bracket
Knockout ring in bracket.
Knockout ring removed.
Neutral terminal
Connector block
Ground strap
Power cord
31
Operating
Instructions
Care and Cleaning
Installation
Instructions
Troubleshooting Tips
Safety Instructions
Consumer Support
Loading ...
Loading ...
Loading ...