Loading ...
Loading ...
Loading ...
175
Maintenance
Other Information Maintenance
Replacement Lamp
This projector uses the following lamps.
Lamp part no.: RS-LP11
Contact the Canon Customer Support Center when purchasing a replacement
lamp.
Precautions when replacing lamps that stop working
If the illumination suddenly stops when the projector is in use or after
you turn it on, the lamp may be broken. In this case, never attempt to
replace the lamp by yourself. Always request service from the
qualified technician or Canon Customer Support Center. Additionally,
with ceiling-mounted projectors, the lamp may fall out when you open
the lamp cover or while you are attempting to replace it. During
replacement, stand to the side of the lamp cover, not directly under it.
If the lamp breaks and any glass shards or other pieces get in your
eyes or mouth, consult a doctor immediately.
Before replacing the lamp, always turn off the projector, unplug it after
the cooling fan stops, and wait at least one hour. Do not touch the
lamp immediately after turning the projector off. It is very hot initially
and poses a risk of burns.
• Be sure to use the specified lamp.
• Contact the Canon Customer Support Center for further information.
This can also be purchased from the Canon website.
• Do not touch the inner glass surface when you replace the lamp.
Doing so may cause deterioration to the projector’s performance.
• Handle lamps with care. Impact or abrasion may cause lamps to
rupture while they are in use. If a lamp ruptures, contact the Canon
Customer Support Center and follow the instructions in “Note the
following precautions when replacing lamps that stop working.
Failure to do so could result in personal injury.” (P18).
• When replacing the lamp, do not remove any screws other than
those specified.
Loading ...
Loading ...
Loading ...