Loading ...
Loading ...
Loading ...
MRF-350 BASE STATION
Page 6
Connecting IR and Setting Output Levels
1. Connect an IR emitter to each IR output and run the emitter wire to the
front panel of each component. DO NOT STICK the emitter in place.
ADJUST the level first.
2. Adjust each of the IR Output levels for best operation. If the component
operates best at minimum level, but is still operating sluggishly or intermit-
tently, move the emitter farther away from the components IR sensor.
NOTE: TiVo, Replay TV, Satellite Receivers and Cable Boxes are all extremely
sensitive to IR overload or saturation. Put up the on screen guide and test the
navigation arrows. Compare operation via RF to the original remote control.
Operation should be identical. RF is not slower. If operation is inconsistent or
sluggish, LOWER the IR line output.
If you still have sluggish operation, check that the remote control is set to a
particular LINE OUT, rather than ALL. When IR commands are sent to all the
flashers in a cabinet, you can have difficulty adjusting the IR Output.
Reprogram the remote control to send IR commands only via a specific (1-6)
Line Output, then readjust the IR Line Output level.
Copper colored
conductor is
GROUND
(Sleeve of
the Plug).
Silver colored
conductor is IR
DATA (Tip of
the Plug).
When connecting to a components rear panel
IR Input, cut the flasher off of the wire, strip the
two conductors and connect to the rear panel
IR Input. The MRF-350 is only compatible with
standard IR Inputs, not proprietary control sys-
tems offered by some manufacturers.
Loading ...
Loading ...
Loading ...