Loading ...
Loading ...
Loading ...
4
USING THE MODEL 270 SHARPENER
Note: Always clean your knife before sharpening in the Hybrid
®
! For your safety, keep your
fingers clear of the blade edge at all times.
You will find that the Hybrid
®
can create and maintain a very sharp and effective edge
on all your conventional fine edge and serrated cutlery. The primary edge facets are each
formed in Stage 1 at a nominal 20 degrees on each side of the edge, which results in a total
primary edge of 40 degrees. Stages 2 and 3 create a second and third bevel at slightly larger
angles leaving a strong triple beveled edge structure. Always use the sharpener with the
stage numbers 1, 2 and 3 facing you.
STAGE 1
To sharpen, place the sharpener on the table gripping it securely with your left hand. Push
on the power switch. Insert the knife blade, (Figure 1) near its handle, into the far left slot of
Stage #1 and allow the left face of the blade to rest on the left face of the slot as you pull the
knife toward you. The knife edge should be in sustained moving contact with the internal dia-
mond abrasive coated disk. Only light downward force will be necessary as you pull the blade
toward you. Listen carefully to insure your knife maintains good contact with the rotating
diamond disk. Take about 5 seconds to make each pull if you have a six inch (6”) long blade.
Increase the time of each pull for longer blades or decrease the time for shorter blades.
Make one pull of the blade in the left slot as described above and then repeat the same
procedure in the adjacent (right) slot of Stage 1. As you pull the knife thru the right slot,
(see Figure 2), hold the right face of the knife against the slanted right face of the slot. If
your knife, before sharpening, is not very dull you will find that only about 5 pairs of pulls,
alternating in the left and right slots of Stage 1, will be sufficient to put a keen edge on the
Figure 1. Inserting the blade in the left slot of the
Stage 1. Alternate individual pulls in left and right slots.
Figure 2. Inserting the blade in the right slot of Stage 1.
Alternate pulls in left and right slots.
Loading ...
Loading ...
Loading ...