Loading ...
Loading ...
Loading ...
Do not use vent runs longer than those
specified in Vent Length Chart.
Exhaust systems longer than those speci-
fied will:
• Shorten the life of the dryer.
• Reduce performance, resulting in longer
drying times and increased energy
usage.
3, Determine the number of elbows you
will need.
in the column listing the type of metal
vent you are using (rigid metal or flex-
ible metal), find the maximum length
of metal vent on the same line as the
number of elbows.
Vent Length Chart
Numberof Type of Boxor Angled
90° turns vent Louvered hoods
or elbows hoods
Alternate installations for close
clearances
Venting systems come in many vari-
eties. Select the type best for your
installation. Two close-clearance instal-
lations are shown. Refer to the manu*
facturer's instructions.
1.Over-The-Top installation (also
available with one offset elbow)
2. Periscope installation
Side and bottom installations
This dryer can be converted to exhaust
.............................................................................................................................................................................................................................................out the right side, left side, or through
0 Rigidmetal 64ft (20m) 58It(17.7m) the bottom.
Flexiblemetal 36ft (11m) 28ft
1 Rigidmetal 54ft (16.5m) 48It(14.6m)
Flexiblemetal 31ft (9.4m) 23It(7 m)
2 Rigidmetal 44ft (13.4m) 38It(11.6m)
Flexiblemetal 27ft(8.2m) 19ft(5.8m)
3 Rigidmetal 35ft (10.7m) 29_(8.8m)
Flexiblemetal 25ft (7.6m) 17It(5.2m)
4 Rigidmetal 27ft (8.2m) 21ff(6.4m)
Flexiblemetal 23ft (7m) 15ft(4.6m)
NOTE: Side and bottom exhaust installa-
tions have a 90° turn inside the dryer, To
determine maximum exhaust length, add
one 90° turn to the chart.
Fire Hazard
Cover unused exhaust holes with
one of the following kits:
279818 (white)
279819 (almond)
279915 (graphite)
279925 (biscuit)
Contact your local dealer.
Failure to follow these instructions
can result in death, fire, electrical
shock, or serious injury.
17
Loading ...
Loading ...
Loading ...