Loading ...
Loading ...
Loading ...
10
8. Using 2 no. 6 x 1/2’’ screws, assemble the adapter/damper to the hood.
NOTE: Damper fl ap pivot (1) to the front of the hood for vertical discharge and for horizontal discharge,
damper fl ap pivot to top of hood.
9. Seal the adapter/damper to the hood using duct tape.
PREPARE THE HOOD
HO0082
1
HO0083
HO0084
1
HO0085
1. Run power cable to installation location. Position the hood in its intended location. Using a pen, mark the position
of the screws (smaller part of the keyhole, see picture below for the 5 keyhole locations). Remove the hood.
Install 4 no. 8 x 1/2’’ screws, leaving a 1/8’’ gap. Do not install the no. 5 screw yet.
INSTALL THE HOOD
HD0168
1
2
3
4
5
2. Attach the wire clamp, insert the power cable in the hood and tighten the wire clamp to secure the cable. Place the
hood under the cabinet and slide it in position. Make sure the adapter/damper assembly enters the duct opening.
Tighten the 4 screws completely, then add the last screw (screw no. 5) in the center keyhole. Make sure the damper
fl ap opens freely.
HORIZONTAL DISCHARGEVERTICAL DISCHARGE
Loading ...
Loading ...
Loading ...