Loading ...
Loading ...
Loading ...
Changing the Needle
(1} Needle clamp screw
_2}Needle clamp
_3}Flat side
_4_Gap
[lJ Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and lowering
the presser foot. Loosen the needle clamp screw (1}by
turning it counterclockwise. Remove the needle from the
needle clamp @}.
[2JInsert a new needle into the needle clamp (2}with the
flat side to the rear. When inserting the needle into the
needle clamp (2}, push it up as far as it goes. Tighten
the needle clamp screw (i} firmly by turning it clockwise.
[3JTo see if the needle is good, place the flat side _3}of the
needle onto something flat (needle plate, glass, etc.).
The gap _4}between the needle and the flat surface
should be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
Changing the Presser Foot
CAUTION:
When attaching or removing presser foot, turn OFF the
power switch and remove the needle from the needle
clamp.
• To attach
Insert the presser foot pin (1} into the slit (2} of the presser
holder and push the presser foot to lock it in place.
• To remove
Pull the foot in the direction of arrow to remove the presser
foot.
f- •
,/
To Remove and Attach the Foot Holder
CAUTION:
When attaching or removing foot holder, turn OFF the
power switch and remove the needle from the needle
clamp.
•To remove
Remove the setscrew by turning it counterclockwise with a
screwdriver and remove the foot holder.
•To attach
Match the hole in the foot holder with the threaded hole in
the presser bar. Fit the setscrew into the hole. Tighten the
screw by turning it clockwise with a screwdriver.
(1} Setscrew
Foot holder
(3} Hole
(4} Threaded hole
- J
10
Loading ...
Loading ...
Loading ...