Loading ...
Loading ...
Loading ...
en Rinse aid
16
Top up the rinse aid as follows:
1. Open dispenser 92; press lug on
the lid (1) and lift (2).
2. Add rinse aid up to the max. mark.
3. Close the lid.
The lid "clicks" into position.
4. Remove overflowed rinse aid with a
cloth.
This prevents excessive frothing
during the next rinse cycle.
Setting amount of rinse aid
You can set the amount of rinse aid that
should be added to a value between
§:‹‹ and §:‹‡. Setting the amount of
rinse aid to be dispensed to §:‹† will
give you a very good drying result. The
factory setting is §:‹†. Do not change
the amount of rinse aid unless there are
streaks or water stains on the utensils.
Set a lower level to avoid streaks. Set a
higher level to avoid water stains.
Here’s how to set the amount of rinse
aid:
1. Switch on ON/OFF switch (.
2. Press and hold the ‹ button
for 3 seconds.
The value •:‹... and ‘ will appear in
the display window )". .
3. Press the ‹ button repeatedly
until the factory setting value §:‹†
appears in the display window )".
4. Adjust the setting using the buttons -
and + P.
5. Press and hold the ‹ button
for 3 seconds.
The chosen setting has now been
stored in your dishwasher.
Using detergent with a rinse
aid component
Det er gent wi t h a ri nse ai d component
In general, you can use detergent with
a rinse aid component up to a water
hardness level of 21 °dH (37 °fH, 26
°Clark, 3.7 mmol/L) without adding
rinse aid. Above a water hardness value
of 21 °dH, use additional rinse aid.
Switching off rinse aid refill
indicator
If the rinse aid refill indicator @
bothers you (e.g. if you are using a
combination detergent with a rinse aid
component), you can switch off the
rinse aid refill indicator.
Proceed as described under "Setting
rinse aid quantity" and set the level to
§:‹‹. The rinse aid refill indicator @ is
switched off.
2
1
PD[
Loading ...
Loading ...
Loading ...