Loading ...
Loading ...
Loading ...
9
■ Is the dryer located in a room with temperature below
45ºF (7ºC)?
Proper operation of dryer cycles requires temperatures above
4
5ºF (7ºC).
■ Is the dryer located in a closet?
Closet doors must have ventilation
openings at the top and
bottom of the door. Sides and front of dryer require a minimum
of 1" (25 mm) of airspace, and the rear of the dryer requires 5"
(127 mm). See the Installati
on Instructions.
■ Has an air dry cycle been selected?
Select the right cycle for the types of gar
ments being dried.
■ Is the load too large and heavy to dry quickly?
Separate the load to tumble freely.
Cycle time too short
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
■ Is the automatic cycle ending early?
The load may not be contacting the sensor strips. Level the
dryer
.
Change the dryness level sett
ing on Automatic Cycles.
Increasing or decreasing the dryness level will change the
amount of drying time in a cycle.
Lint on load
■ Is the lint screen clogged?
Lint screen should be cleaned before each load.
Stains on load or drum
■ Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the
beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in
clothing (usually blue
jeans). This will not transfer to other clothing.
Loads are wrinkled
■ Was the load removed from dryer at the end of the cycle?
■ Was the dryer overloaded?
Dry smaller loads that can tumble freely.
Odors
■ Have you recently been painting, staining, or varnishing in
the area where your dryer is located?
If so, ventilate the area. When the odors or fumes are gone
fr
om the area, rewash and dry the clothing.
■ Is the electric dryer being used for the first time?
The new electric heating element may have an odor. The odor
will be gone
after the first cycle.
Loading ...
Loading ...
Loading ...