Loading ...
Loading ...
Loading ...
Installing your new appliance
Ventilation of appliance
●
Before using the appliance for the first
time, the following
tips.
please consider
In order to improve efficiency
of the cooling system and save
energy, it is necessary to maintain
good ventilation around the appliance
dissipation of heat. For this
reason, sufficient clear space should
be available around the refrigerator.
It is advisable for there to be at least
75mm of space from the back to the
wall, at least 100mm from its top,at
last 100mm from its side to the wall
and a clear space in front to allow the
doors to open 135° shown in
following diagrams.
to allow
as
Note:
This appliance performs well within
the climate class showed in the table
below.
75
100
100
100
75
100
100
100
It may not work properly if being left at
a temperature above or below the
indicated range for a long period.
Leveling of appliance
For sufficient leveling and air
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. You can adjust
them manually by hand or by using a
suitable spanner.
To allow the doors to self-close, tilt
the top backwards by about 10mm.
Climate class
Ambient temperature
SN
N
ST
T
+10C to +32C
+16C to +32C
+16C to +38C
+16C to +43C
Stand your appliance in a dry place
to avoid high moisture.
Keep the appliance out of direct
sunlight
， rain or frost. Stand the
appliance away from heat sources
such as stoves, fires or heaters.
●
●
●
●●●
●
≤10mm
Installing the door handles
For the convenience of transportation,
the door handles are separately
provided in a plastic bag, you can
install the door handles as follows.
1. Lever screw covers on the left
side of the door, and then put them
back to the plastic bag.
2. Match the handle on the left side of
the door, keeping
screw holes in the handle and the
door in a line, as the picture shows.
out
in
the center of the
3. Fix the handle with the special
screws provided in the plastic
bag. install the handle covers.Then
7
Hisense Refrigerator
Loading ...
Loading ...
Loading ...