Loading ...
Loading ...
Loading ...
Troubleshooting 201
5
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Error messages
When erroneous operations are performed messages and advice on operation will be displayed on the LCD.
Follow what is displayed. The message may disappear if the operation is performed correctly. The message will
disappear if is pressed while the message is displayed.
Error Message Probable Cause
There is a possibility that the data for the selected pattern is corrupted.
Either the “Start/Stop” button or the “Reverse/Reinforcement Stitch”
button was pressed at a screen other than the sewing screen.
The “Start/Stop” button was pressed without connecting the foot
controller while the setting for adjusting the stitch width using the
sewing speed controller is set to “ON” (Refer to page 111).
You have selected a pattern for which width control cannot be used.
The twin needle setting is selected while a pattern that cannot be sewn
with the twin needle is selected.
Press to cancel the twin needle setting. If the twin needle is
installed, replace it with a single needle. Then, select the pattern again.
Press to return to the previous screen.
Upper thread broken.
Upper thread not set up correctly.
Upper thread has run out.
CAUTION
Be sure to rethread the machine. If you press the “Start/Stop” button
without rethreading the machine, the thread tension may be wrong or
the needle may break and cause injury.
You tried to create a design with too many points with the My Custom
Stitch function.
The machine is deleting a previously saved pattern while in embroidery
edit mode.
The “Start/Stop” button was pressed while the foot controller was
connected.
You tried to use the foot controller for embroidery.
You attempted to select a pattern after the USB media containing the
pattern has been disconnected, then reconnected.
The “Start/Stop” button was pressed before the editing was completed
with the My custom stitch function.
on the LCD was pressed when no card was inserted.
Loading ...
Loading ...
Loading ...