Loading ...
Loading ...
Loading ...
Decorative Rear Trim installation
(if required)
I. Disconnect the power from the range.
2. Make sure the range is leveled.
3. Pull range toward you.
4. Take the distance between the floor and the surface
underneath the cooktop frame.
5. Mark that distance on the wall where the decorative
trim will be installed.
6. Draw a line.
7. Place the top of the decorative trim under that line.
8. Using the screws provided fix the decorative trim
into the wall.
9. Slide the range back into position and reconnect the
power source (the bottom of the cooktop should be
located over the decorative trim).
Trim
Figure 11
Check Operation
Refer to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
2, Operation of Oven Elements
The oven is equipped with an electronic oven control. Each
of the functions has been factory checked before shipping.
However, it issuggested that you verify the operation of
the electronic oven controls once more. Refer to the Use &
Care Guide for operation. Follow the instructions for the
Clock, Timer, Bake, Broil, Convection (some models) and
Clean functions.
Bake-After setting the oven to 350°F (177°C) for baking,
the lower element in the oven should become red.
Broil-When the oven is set to BROIL,the upper element
in the oven should become red.
Clean-When the oven is set for a self-cleaning cycle, the
upper element should become red during the preheat
portion of the cycle. After reaching the self-cleaning
temperature, the lower element will become red.
Convection (some models)-When the oven is set to
CONV. BAKE/ROASTat 350% (177°C), the convection
element cycles on and off and the convection fan turns.
The convection fan will stop turning when the oven door
is opened during convection baking or roasting.
Warmer Drawer (some models)-Set the control knob
to HI and check to see the drawer is heating.
When Power Connection is Completed
Make sure all controls are left in the OFF position.
Model and Serial Number Location
The serial plate is located on the oven front frame
behind the oven door (somemodel_ or behind the
drawer (some models).
When ordering parts for or making inquiries about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your range.
Do not touch the elements. They may be
hot enough to cause burns.
Remove all packaging from the oven and the warmer
drawer (if equipped) before testing.
1. Operation of Surface Elements
Turn on each of the four surface elements and check to
see that they heat. Check the surface element indicator
light(s), if equipped.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use & Care Guide. It may
save you time and expense. The list includes common
occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to your Use & Care Guide for Searsservice phone
numbers, or call 1-800-4-MY-HOME%
10
Loading ...
Loading ...
Loading ...