WMA8168LB1 User Manual

Loading ...

Washing Machine /User’s Manual

13 / EN

Installation

3.5 Connecting to the drain

•Theendofthedrainhosemustbedirectly

connected to the wastewater drain or to the

washbasin.

WARNING: Your house will be flooded

if the hose comes out of its housing

during water discharge. Moreover, there

is risk of scalding due to high washing

temperatures! To prevent such situations

and to ensure smooth water intake and

discharge of the machine, fix the end

of the discharge hose tightly so that it

cannot come out.

•Thehoseshouldbeattachedtoaheightofat

least 60 cm, and 90 cm at most.

•Incasethehoseiselevatedafterlayingiton

the floor level or close to the ground (less than

60 cm above the ground), water discharge

becomes more difficult and the laundry may

come out excessively wet. Therefore, follow the

heights described in the figure.

•Topreventflowingofdirtywaterbackintothe

machine and to allow for easy discharge, do not

immerse the hose end into the dirty water or do

not drive it in the drain more than 15 cm. If it is

too long, cut it short.

•Theendofthehoseshouldnotbebent,it

should not be stepped on and the hose must

not be pinched between the drain and the

machine.

•Ifthelengthofthehoseistooshort,useitby

adding an original extension hose. Length of the

hose may not be longer than 3.2 m. To avoid

water leak failures, the connection between

the extension hose and the drain hose of the

product must be fitted well with an appropriate

clamp as not to come off and leak.

3.6 Adjusting the feet

WARNING: In order to ensure that

the product operates more silently

and vibration-free, it must stand level

and balanced on its feet. Balance the

machine by adjusting the feet. Otherwise,

the product may move from its place and

cause crushing and vibration problems.

1. Loosen the lock nuts on the feet by hand.

2. Adjust the feet until the product stands level

and balanced.

3. Tighten all lock nuts again by hand.

WARNING: Do not use any tools to

loosen the lock nuts. Otherwise, they will

get damaged.

Loading ...

User Manual - Page 13