Loading ...
Loading ...
Loading ...
PRINCIPLE OF OPERATION
WARNINGS
The system may not detect objects
with surfaces that absorb reflection.
Always drive with due care and
attention. Failure to take care may result
in a crash.
To help avoid personal injury, always
use caution when in reverse (R) and
when using the sensing system.
The system may not detect small or
moving objects, particularly those
close to the ground.
Note: Certain add-on devices installed
around the rear fascia such as large trailer
hitches, bike or surfboard racks or certain
add-on devices installed around the front
fascia such as license plate brackets or
frames, bumper covers, bumper guards or
any other device that may block the normal
detection zone of the system, may create
false beeps.
Note: In these cases the add-on devices
must be removed in order to prevent the
false beeps.
Note: Keep the sensors free from snow, ice
and large accumulations of dirt. Blocked
sensors may affect system accuracy. Do
not clean the sensors with sharp objects.
Note: If your vehicle sustains damage to
the bumper or fascia, leaving it misaligned
or bent, the sensing zone may be altered
causing inaccurate measurement of
obstacles or false alarms.
Note: When a trailer is connected to the
vehicle, the Rear Sensing System may
detect the trailer and therefore provide
warnings. It is suggested that the driver
disables the Rear Sensing System when a
trailer is connected to the vehicle to prevent
these warnings.
We recommend that you take some time
to get to know the system and its
limitations by reading this section.
The sensing system warns the driver of
obstacles within a certain range of your
vehicle. The system automatically turns
on each time you switch the ignition on.
The system may provide display or sound
warnings when the detected obstacle is
30 cm or less from the bumper.
The system can be switched off through
the information display menu or from the
pop-up message that appears once you
shift the transmission into reverse (R). If
your vehicle is equipped with a front
sensing system, you can switch the system
off using the parking aid button. See
Information Messages (page 65).
If a fault is present in the system, a warning
message appears in the information
display and does not allow you to switch
the system on.
See Information Messages (page 65).
REAR PARKING AID
The rear parking aid sensors automatically
turn on when you shift into reverse (R).
As your vehicle moves closer to the
obstacle, the rate of the audible warning
increases. When the obstacle is less than
30 cm the warning sounds continuously.
If the system detects an object farther than
30 cm from the corners of the bumper, the
tone sounds for only three seconds. If the
system detects an approaching object the
warning sounds again.
111
EcoSport (CBW) India, Vehicles Built From: 14-08-2017, GN15-19G219-ZCA enIND, Edition date: 201708, First Printing
Parking Aids (If Equipped)
Loading ...
Loading ...
Loading ...