Loading ...
Loading ...
Loading ...
359
4-5. Using the driving support systems
4
Driving
operation. The indicator will flash
during operation, and then go off
when the system is fully off.
■ When the downhill assist con-
trol system is operated continu-
ously
This may cause the brake actuator
to overheat. In this case, the down-
hill assist control system will stop
operating, a buzzer will sound and
the downhill assist control system
indicator will start flashing. Refrain
from using the system until the
downhill assist control system indi-
cator stays on. (The vehicle can be
driven normally during this time.)
■ Sounds and vibrations caused
by the downhill assist control
system
● A sound may be heard from the
engine compartment when the
engine is started or just after the
vehicle begins to move. This
sound does not indicate that a
malfunction has occurred in down-
hill assist control system.
● Either of the following conditions
may occur when the downhill
assist control system is operating.
None of these are indicators that a
malfunction has occurred.
• Vibrations may be felt through the
vehicle body and steering.
• A motor sound may be heard after
the vehicle comes to a stop.
■ System malfunction
In the following cases, have your
vehicle checked by your Toyota
dealer.
● The downhill assist control system
indicator does not come on when
the engine switch is turned to ON.
● The downhill assist control system
indicator does not come on when
the “DAC” switch is pressed.
● The slip indicator light comes on.
WARNING
■ The system may not operate
on the following surfaces,
which may lead to an acci-
dent causing death or serious
injury
● Slippery surfaces such as wet
or muddy roads
● Icy surface
● Unpaved roads
Loading ...
Loading ...
Loading ...