Loading ...
Loading ...
Loading ...
Cleaning and maintenance en
41
Drain pump blocked
:Warning
Risk of scalding!
When you wash at high temperatures,
the water gets very hot. If you come into
contact with the hot water, you may be
scalded.
Allow the water to cool down.
1. Turn off the tap so that no more
water can flow in and has to be
drained via the drain pump.
2. Switch off the appliance. Pull out the
mains plug.
3. Open and remove the service flap.
4. Take the drain hose out of the
retainer.
Remove the sealing cap and pour
the water out into a suitable
container.
Replace the sealing cap and place
the drain hose back in the retainer.
5. Carefully unscrew the pump cover;
residual water may leak out.
Clean the interior, pump-cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
6. Place the service flap back on, lock
it into place, and close it.
Note: To prevent unused detergent
from flowing into the outlet during the
next wash: Pour 1 litre of water into
dispenser II and start the Spin/Drain 0/
[programme: (if only a drained cycle
is required: set 0 rpm (spin speed) to
0).
Drainage hose on the siphon
blocked
1. Turn the programme selector to Off.
Pull out the mains plug.
2. Loosen hose clip, carefully remove
drainage hose. Residual water may
run out.
3. Clean drainage hose and siphon
spigot.
4. Re-attach the drainage hose and
secure the connection point with the
hose clip.
Loading ...
Loading ...
Loading ...