Loading ...
Loading ...
Loading ...
en Positioning and connecting
18
Before washing/drying for the
first time
The washer dryer was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum Clean
Û programme the first
time without laundry.
Note:
■ The washer dryer must have been
installed and connected properly.
Installation and connection
~ Page 12
■ Never switch on a damaged washer
dryer. Inform your customer
service.~ Page 46
1. Insert mains plug.
2. Turn the tap on.
3. Switch on the appliance.
4. Close the door. Do not load any
laundry.
5. Select the Drum Clean
Û40°C
programme.
6. Open the detergent drawer.
7. Pour approx. 1 litre of water into
dispenser II.
8. Add standard detergent to
dispenser II according
to manufacturer’s instructions for
light soiling.
Note: To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
9. Close the detergent drawer.
10.Select A Start/Reload.
11.When the programme ends, switch
off the appliance.
Your washer dryer is now ready for
use.
Transportation
Preparatory work
1. Turn off the tap.
2. Release the water pressure in the
supply hose.
Filter in the water inlet hose blocked
~ Page 42
3. Drain any residual washing water.
Drain pump blocked ~ Page 41
4. Disconnect the washer dryer from
the power supply.
5. Remove the hoses.
Installing transportation protection
devices:
1. Remove the covers and keep in a
safe place.
If required, use a screwdriver.
2. Insert all 4 sleeves.
Clamp the mains cable on the
holders. Insert and tighten the bolts.
Before switching on the appliance:
Notes
■ Always remove the transportation
protection devices!
■ To prevent unused detergent from
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser II and start the Spin/Drain
0/[ programme.
Loading ...
Loading ...
Loading ...