Loading ...
Loading ...
Loading ...
Operating the appliance en
31
For drying programmes:
1. Select Intensive Dry or Gentle Dry.
2. Touch Š Dry button, and set drying
time to 20 minutes.
3. Touch A Start/Reload button.
End of the programme
End or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal
If – – – – (Rinse stop = without final
drain/spin cycle) was selected, press
A Start/Reload button to start the final
drain/spin cycle.
Notes
■ The programme continues by
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
■ If only the water is to be pumped out,
approx. 1 minute after the
programme starts, touch the A
Start/Reload button before the spin
cycle starts. The programme is
interrupted and the door lock is
released. The laundry can be
removed.
■ If Hot flashes in the display before
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
■ Wrinkle guard process starts after
drying process is finished to prevent
laundry getting wrinkle if you do not
take laundry out in time. The process
lasts about 30 minutes. 0:00 will be
displayed in time display and o
symbol will be displayed as the
status symbol. You can press any
button or rotate the programme
selector to another position to
terminate this process, then the door
will be released and laundry can be
taken out.
After washing/drying
1. Open the door and remove the
laundry.
2. Turn the programme selector to Off.
The appliance is switched off.
3. Turn off the tap.
Not required for Aqua-Stop models.
Notes
■ Do not leave any items of laundry in
the drum. In the next wash they may
shrink or discolour another item.
■ Remove any foreign objects from
the drum and the rubber seal – risk
of rust.
■ Leave the detergent drawer and
door open so that residual water can
evaporate.
■ Always remove the laundry.
■ Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for the unlocking device.
■ When the display panel has gone
out at the end of the programme,
energy-saving mode is active. To
activate the display again, select any
button.
Loading ...
Loading ...
Loading ...