Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
35
ArtNo.320-0005 Oven door rubber seal
ArtNo.320-0002a Proplus oven door side screws
ArtNo.320-0006 Oven door hinge adjustment 1
ArtNo.320-0007 Oven door hinge adjustment 2
Fig.9-12
Fig.9-13
Fig.9-11
6.2 To Replace an Oven Door
Open the oven door. Support the door and loosen the
two screws securing the upper hinge and gasket to the
cooker front (Fig.9-9).
The door is heavy, so take care.
Support the door and remove the screw nearest the
hinge pin (Fig.9-10). Swing the hinge up and away from
the door hinge pin. Lift the door away from the lower
hinge and remove.
Reassemble in the reverse order.
6.3 To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted
to alter the angle of the door (Fig.9-11). Loosen the
bottom hinge xing screws and use the notch and a at
bladed screwdriver to move the position of the hinge to
set the hinge position (Fig.9-12).
Retighten the hinge screws.
6.4 To Replace an Oven Door Outer Panel
Move the cooker forwards to gain access to the sides.
Open the oven door slightly and remove the 4 front
panel xing screws from the door sides (two each side),
(Fig.9-13).
Carefully lift o the outer door panel.
Remove the door handle from the panel by unscrewing
the two retaining nuts.
Fit the door handle to the new panel.
Fit the panel to the door. Reassemble in the reverse
order.
6.5 To Change the Oven Door Latch
Remove the outer door panel (see 6.3). Remove screws
‘B’, which hold the latch assembly to the inner door
panel (Fig.9-14). Fit the new catch and reassemble in
reverse order. Check the door operation.
6.6 To Adjust an Oven Door Catch Keep
Open the oven door, slacken o the locknut at the base
of the keep, and screw in or out as required until the
required t is obtained. Retighten the locking nut
(Fig.9-15).
6.7 To Change an Oven Door Seal
Open the oven door. The seal is held in place by small
hooks on the rear face. At the corner, pull the seal
diagonally away from the door centre until that hook
is released (Fig.9-16). Proceed to the next hook and
release it in a similar way, and so on. Use force if the
hooks are sti, as the old seal will be discarded.
When tting the new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of
the door, and proceed round the door, snapping in each
hook in turn.
Eect of hinge adjustment – exagerrated for clarity
Centreline of hinge pin
Oven door omitted for clarity
ArtNo.320-0003 Oven door latch
B
Fig.9-14
ArtNo.320-0004 Oven door keep
Fig.9-15
Fig.9-16
Loading ...
Loading ...
Loading ...