Loading ...
Loading ...
Loading ...
11
2 hours
3 hours
5. Press the OK icon (B15) to conrm (or ESC
(B14) to exit without making the change). The lights go o.
The auto-o time is now programmed.
9. ENERGY SAVING
Use this function to enable or disable energy saving. This mode
is active by default, reducing energy consumption while the ma-
chine is on in compliance with current European regulations. To
change the setting, proceed as follows:
1. With the machine o (standby), but the main switch
pressed (A6) (g. 1);
2. Press and hold the icon (B9) until the icons on the
touch screen (B) come on.
3. Press the icon (B13);
4. Press the icon again to enable/disable the function:
• function enabled
• function disabled
5. Press the OK icon (B15) to conrm (or ESC
(B14) to exit without making the change). The lights go o.
The energy saving setting is now programmed.
Please note:
• When in energy saving mode, a few seconds may elapse
before the rst coee is delivered as the machine must
heat up again.
10. BEEP
This function enables or disables the beep. Proceed as follows:
1. With the machine o (standby), but the main switch
pressed (g. 1);
2. Press and hold the icon (B9) until the lights on the
touch screen (B) come on.
3. Press the icon to enable/disable the function:
• function enabled
• function disabled
4. Press the OK icon (B15) to conrm (or ESC
(B14) to exit without making the change). The lights go o.
The beep is now programmed.
11. DEFAULT VALUES RESET
This function resets all settings (temperature, auto-o, water hard-
ness, energy saving and all quantity settings are reset to the default
values).
1. With the machine o (standby), but the main switch
pressed (g. 1);
2. Press and hold the icon (B9) until the lights on the
touch screen (B) come on.
3. Press the icon (B12). The beans (B7) on the touch
screen ash;
4. Press the OK icon (B15) to reset the default values
(or
ESC (B14) to exit without making the change).
The lights go o.
The settings and quantities of the beverages have been reset to
the default values.
12. RINSING
Use this function to deliver hot water from the coee spouts
(A19) to clean and heat the machine’s internal circuit.
Place a container with a minimum capacity of 3.38 oz/100ml
under the coee and hot water spouts.
Important! Danger of burns.
Do not leave the machine unattended while hot water is being
delivered.
1) To activate the function, press OK (B15);
2) After a few seconds, hot water is delivered from the coee
spouts, cleaning and heating the machine’s internal circuit.
3) To interrupt the function manually, press OK again.
Please note:
• If the machine is not used for more than 3-4 days, when
switched on again, we strongly recommend performing
2/3 rinses before use;
• After cleaning it is normal to have water collected in the
coee ground container (A11).
13. MAKING COFFEE
13.1 Adjusting the coee grinder
The coee grinder is set by default to prepare coee correctly
and should not require regulating initially.
However, if after making the rst few coees you nd that the
coee is either too weak and not creamy enough or delivery is
too slow (a drop at a time), this can be corrected by calibrating
the coee grinding using the adjusting dial (A5) (g. 8).
Please note:
The grinding adjustment dial must only be turned when the
coee grinder is in operation.
Loading ...
Loading ...
Loading ...