Loading ...
Loading ...
Loading ...
10
4. TURNING THE MACHINE ON
Please note:
Before turning the machine on, make sure the main switch (A6)
on the back of the machine is pressed (g. 1).
Each time the machine is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The ma-
chine is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
(A19) and is collected in the drip tray (A15) underneath. Avoid
contact with splashes of water.
• To turn the machine on, press the button (A24) (g.
7). The light (B1) ashes on the touch screen (B) to in-
dicate the machine is heating up.
While heating up, the machine performs a rinse cycle. As well
as heating the boiler, this also heats the internal circuits by cir-
culating hot water.
The machine is at temperature when the light on the touch
screen goes o and the coee icons come on.
5. TURNING THE MACHINE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts
(A19). Avoid contact with splashes of water.
• To turn the machine o, press the button (A24 - g.
7);
• the light (B1) ashes on the touch screen and (if pro-
vided for) the machine performs a rinse cycle then goes o
(standby).
Please note:
If you will not be using the machine for some time, unplug from
the mains socket:
• rst turn the machine o by pressing the button;
• release the main switch (A6) (g. 1).
Important!
Never press the main switch while the machine is on.
6. SETTING WATER HARDNESS
For instructions on setting water hardness, see section “19. Set-
ting water hardness”.
7. SETTING TEMPERATURE
If you want to modify the temperature of the water used to
make the coee (low, medium, high, maximum), proceed as
follows:
1. With the machine o (standby), but the main switch
pressed on (A6) (g. 1);
2. Press and hold the icon (B9) until the lights on the
touch screen (B) come on;
3. Press the icon (B10);
4. Press the icon again to select the required
temperature:
low
medium
high
maximum
5. Press the OK icon (B15) to conrm (or ESC
(B14) to exit without making the change).
The lights go o.
The machine returns to "standby" and the temperature is now
programmed.
8. AUTOOFF
The time can be changed so that the machine switches o after
being idle for 15 or 30 minutes, or after 1, 2 or 3 hours.
To change the Auto-o setting, proceed as follows:
1. With the machine o (standby), but the main switch
pressed on (A6) (g. 1);
2. Press and hold the icon (B9) until the icons on the
touch screen (B) come on;
3. Press the icon (B11);
4. Select the required time interval by pressing the icon
again:
15 min.
30 min.
1 hour
Loading ...
Loading ...
Loading ...