Loading ...
Loading ...
Loading ...
5. Screw the connection hose onto the tire
valve of the defective wheel.
6. With the compressor switched off, insert
the plug into a power socket inside the ve‐
hicle.
7. With the ignition turned on or the engine
running, switch on the compressor.
Let the compressor run for approx. 3 to 8 mi‐
nutes to fill the tire with sealant and achieve a
tire inflation pressure of approx. 2.5 bar.
While the tire is being filled with sealant, the
tire inflation pressure may sporadically reach
approx. 5 bar. Do not switch off the compressor
at this point.
Switch off the compressor after 10 mi‐
nutes
Do not allow the compressor to run longer than
10 minutes; otherwise, the device will overheat
and may be damaged.◀
If a tire inflation pressure of 2 bar is not
reached:
1. Switch off the compressor.
2. Unscrew the filling hose from the wheel.
3. Drive forward and back to distribute the
sealant in the tire.
4. Inflate the tire again using the compressor.
If a tire inflation pressure of 2 bar cannot be
reached, contact your service center.
Stowing the Mobility System
1.
Remove the connection hose of the sealant
container from the wheel.
2. Remove the connection hose from the seal‐
ant container.
3. Wrap the empty sealant container and con‐
nection hose in suitable material to avoid
dirtying the cargo area.
4. Stow the Mobility System back in the vehi‐
cle.
Distributing the sealant
Immediately drive approx. 5 mls/10 km/h to
ensure that the sealant is evenly distributed in
the tire.
Do not exceed a speed of 50 mph/80 km/h.
If possible, do not drive at speeds less than
12 mph/20 km/h.
Seite 185
Wheels and tires
MOBILITY
185
Online Edition for Part no. 01 40 2 961 168 - II/15
Loading ...
Loading ...
Loading ...