Loading ...
Loading ...
Loading ...
NOTE: Ensure the rubber boot is properly reinstalled to
prevent water and moisture from entering the lamp.
CAUTION!
• Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
• Always use the correct bulb size and type for replace-
ment. An incorrect bulb size or type may overheat
and cause damage to the lamp, the bulb socket, or the
lamp wiring.
4. Turn the low or high beam bulb one–quarter turn
counterclockwise to remove from housing.
5. Disconnect the electrical connector and replace the bulb.
Front Turn Signal Lamp
1. Open the hood.
2. Access the back of the headlamp.
NOTE:
• The air filter housing must be removed.
• The windshield washer reservoir may need to be
rotated out of the way by removing the fastener.
• Coolant reservoir (if equipped) will need to be reposi-
tioned by removing the fasteners, and moving the unit
out of the way.
3. Turn the turn signal bulb one–quarter turn counter-
clockwise to remove from housing.
4. Disconnect the electrical connector and replace the bulb.
Rubber Boot Seal
7
IN CASE OF EMERGENCY 401
Loading ...
Loading ...
Loading ...