Loading ...
Loading ...
Loading ...
Unlocking and locking 85
Safety First Operating Instructions Practical Tips Technical Specifications
• The electric windows will work until the ignition has been switched off
and one of the front doors has been opened.
• If necessary, use the safety switch to disable the rear electric windows.
Make sure that they have been disabled.
Note
If the window is not able to close because it is stiff or because of an obstruc-
tion, the window will automatically open again ⇒ page 85. If this happens,
check why the window could not be closed before attempting to close it
again.
One-touch opening and closing*
One-touch opening and closing means you do not have to
hold down the button.
Buttons ⇒ page 84, fig. 49 , , and have two positions
for opening windows and two for closing them. This makes it easier
to open and close windows to the desired position.
One-touch closing
– Pull up the window button briefly up to the second position. The
window closes fully.
One-touch opening
– Push down the window button briefly up to the second position.
The window opens fully.
Restoring one-touch opening and closing
– The automatic open and close function will not work if the battery
has been temporarily disconnected. The function can be restored
as follows:
– Close the window as far as it will go by lifting and holding the
window switch.
– Release the switch and then lift it again for one second. This will
re-enable the automatic function.
If you push (or pull) a button to the first stage, the window will open (or close)
until you release the button. If you push or lift the button briefly to the second
stage, the window will open (one-touch opening) or close (one-touch closing)
automatically. If you operate the button while the window is opening or
closing, it stops at this position.
The one-touch opening and closing function will not function once the igni-
tion has been switched off.
The one-touch function and roll-back function will not work if there is a
malfunction in the electric windows. Contact a specialised workshop.
Roll-back function
The roll-back function reduces the risk of injury when the elec-
tric windows close.
• If a window is obstructed when closing automatically, the window stops
at this point and lowers immediately ⇒ .
• Next, check why the window does not close before attempting it again.
WARNING (continued)
A
1
A
2
A
4
A
5
Ibiza_EN.book Seite 85 Mittwoch, 1. September 2010 5:24 17
Loading ...
Loading ...
Loading ...