Loading ...
Loading ...
Loading ...
16 49-60785 Rev. 1
Care and Cleaning/Preparation
36” All-Refrigerator and All-Freezer Units
Preparing
for vacation
Set the icemaker power switch to the OFF
position and be sure to shut off the water
supply to the refrigerator.
For long vacations or absences, remove
food from the refrigerator/freezer. Set the
control to OFF, and clean the interior with a
baking soda solution of one tablespoon (15
ml) of baking soda to one quart (1 liter) of
water. Leave the door open.
For shorter vacations, remove perishable
foods and leave controls at regular settings.
However, if the room temperature is expected
to drop below 60°F (16°C), follow the same
instructions as for long vacations.
Using the
master light
switch
This feature turns off the lights inside the unit.
The switch is located behind the top access
panel. Lift up the panel to access the switch.
Turning off the master switch does not turn off
all power to the unit.
Refrigerator/
freezer
location
Ŷ Do not install the refrigerator/freezer where
the temperature will go below 55°F (13°C).
It will not run often enough to maintain prop-
er temperatures.
Ŷ Do not install the refrigerator/freezer where
temperatures will go above 100°F (37°C). It
will not perform properly.
Ŷ Do not install the refrigerator/freezer in a
location exposed to water (rain, etc.) or
direct sunlight.
Ŷ Install it on a floor strong enough to
support it fully loaded.
For proper installation, the refrigerator/
freezer must be placed on a level surface
of hard material the same height as the
rest of the flooring. This surface should be
strong enough to support a fully loaded
refrigerator/freezer, or approximately 1,200
lbs. each. See the Installation Instructions
for complete directions.
Master Light
Switch
All-Refrigerator
Master
Light
Switch
All-Freezer
Light bulb
replacement
For upper and lower light bulb replacement, call
for service.
Loading ...
Loading ...
Loading ...