Loading ...
Loading ...
Loading ...
12 49-60785 Rev. 1
Water filter
cartridge
(on some
models)
MWF Water Filter
36” All-Refrigerator and All-Freezer Units
For the maximum benefit of your filtration system, GE Appliances recommends the use of GE Appliances-branded filters
only. Using GE Appliances-branded filters in GE Appliances and Hotpoint
®
refrigerators provides optimal performance
and reliability. GE Appliances filters meet rigorous industry NSF standards for safety and quality that are important for
products that are filtering your water. GE Appliances has not qualified non-GE Appliances-branded filters for use in
GE Appliances and Hotpoint refrigerators and there is no assurance that non-GE Appliances-branded filters meet GE
Appliances standards for quality, performance and reliability.
If you have questions, or to order additional filter cartridges, visit our website at monogram.com or call
Monogram Preferred Service, 800.444.1845. In Canada, call 866.777.7627.
Water filter cartridge
The water filter cartridge is located behind the
top access panel.
When to replace the filter on models with a
replacement indicator light
There is a replacement indicator light for the
water filter cartridge on the temperature control
panel. This light will turn orange to tell you that
you need to replace the filter soon.
The filter cartridge should be replaced when
the replacement indicator light turns red or if
the flow of water to the icemaker decreases.
Removing the filter cartridge
If you are replacing the cartridge, first remove
the old one by slowly turning it to the left. Do
not pull down on the cartridge. A small amount
of water may drip down.
NOTE: To reduce the risk associated with
property damage due to water leakage, read
and follow instructions before installation and
use of this system. Installation and use MUST
comply with all state and local plumbing codes.
Installing the filter cartridge
1. Fill the replacement cartridge with water
from the tap to allow for better flow
immediately after installation.
2. Line up the arrow
on the cartridge and
the cartridge holder.
Place the top of the
new cartridge up
inside the holder.
Do not push it up
into the holder.
3. Slowly turn it to the right until the filter
cartridge stops. DO NOT OVERTIGHTEN.
As you turn the cartridge, it will
automatically raise itself into position. The
cartridge will move about 1/2 turn.
4. Press and hold the RESET WATER
FILTER pad on the temperature control
panel for three seconds to clear the red or
amber lilght.
NOTE: A newly installed water filter cartridge
may cause water to spurt into the icemaker.
Filter bypass plug
You must use the filter bypass plug when a
replacement filter cartridge is not available.
The icemaker will not operate without the filter
or filter bypass plug.
Cartridge
Holder
Filter By-
pass Plug
SmartWater
Loading ...
Loading ...
Loading ...