Loading ...
Loading ...
Loading ...
60
GETTING STARTED
INSTALLATION CHECKLIST
✔ Electrical Power
■ Plug refrigerator into a grounded (earthed) outlet.
✔ Doors
■ If doors need to be removed during installation, see the
“Remove and Replace Refrigerator Doors” and “Remove and
Replace Freezer Door Fronts” sections.
■ Check that handles are secure and installed according to the
instructions.
■ Doors seal completely.
■ Refrigerator is level. (Remove base grille and adjust leveling
feet so they are snug against the floor.)
■ Doors are even across the top. (Use door alignment feature if
necessary.)
■ Base grille is properly attached to the refrigerator.
✔ Ice and Water System (on some models)
■ Connect refrigerator to a cold water supply with 20-120 psi
(138-827 kPa) water pressure, as specified in the instructions.
■ Make sure the household water supply is connected and
turned on.
■ Check that the water supply line behind refrigerator is not
kinked.
■ Only use recommended water supply tubing, copper, or PEX,
as specified in the instructions.
■ Install water filter according to the instructions.
■ Flush water system with 11.4 L (3 gallons) of water, as
specified in the instructions.
■ Check for water leaks at all connections.
■ Turn on ice maker if refrigerator is connected to water supply.
(If not connected to water supply, turn off ice maker.)
WATER FILTER INSTALLATION
■ Locate the water filter compartment in the lower left-hand
side of the refrigerator compartment. Push on the right side of
the filter door to open.
■ Align the arrow on the water filter cap with the cutout notch in
the filter housing and insert filter.
■ Once the filter is inserted, turn the filter clockwise 90°
(1/4 turn) until it locks into the housing.
■ Push water filter door closed to latch.
■ Flush 11.4 L (3 gallons) of water through the water system to
clear air from the water line and to keep the dispenser from
dripping and/or avoiding decreased dispenser flow.
NOTE: If the filter is not installed correctly, water may
dispense at a lower flow rate and there will be slower ice
production. Improper filter installation may also cause the
water filter housing to leak.
✔ Final Checks
■ Install air filter according to instructions in corresponding
packaging.
■ Remove all shipping material.
■ Set temperature controls to the recommended setting.
■ Save instructions and other literature.
■ In order to receive a more complete assistance, please
register your product on www.whirlpool.eu/register
WARNING
Electrical Shock Hazard
Plug into an earthed socket.
Do not remove the earth pin.
Do not use an adapter.
Do not use an extension cable.
Failure to follow these instructions can result in
death, re, or electrical shock.
Loading ...
Loading ...
Loading ...